![]() ![]() M4 Dynamic Laser Power Mode is available only if your controller is updated with Grbl v1.1 or next, with “laser mode” enabled in grbl config ($32=1).LaserGRBL detect GRBL configuration and remove (hide) some options if not compatible with your firmware/configuration. Having a correct grbl configuration is mandatory for the machine to have proper behaviour. Grbl on controller has a knowledge of the size of the machine, the number of motor steps to make a millimetre etc, this is known as “grbl configuration”. Linear move to the point X30, Y20 at programmed F speedĪbsolute positioning / Relative positioningĪ full documentation of g-code can be found here: Ī software called “grbl” that run inside the controller board interprets these commands and translates them into the corresponding motor movements and laser pulses. LaserGRBL use only a reduced set of command, but the full g-code set contains many more commands ( read more).įast move (positioning) to the point X10, Y20 at maximum feed rate G-code include a series of command for positioning, moving, tool management. LaserGRBL talk to your engraver in a standard language called g-code, that it was originally intended for CNC numeric control machine.
0 Comments
Leave a Reply. |